why matlab hangs up when i use 2 channels from analog discovery with data aquisition toolbox
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
clear
s = daq.createSession('digilent')
ch = addAnalogOutputChannel(s,'AD1', 1:2, 'Voltage')
rate = 1e6;
s.Rate = rate;
outputData(:,1) = linspace(-1,1,1000);
outputData(:,2) = linspace(-2,2,1000)';
queueOutputData(s,outputData);
startForeground(s);
hi,
i whant to generate signals on two channels with analog discovery divice, with data aqisition toolbox. While using one channel there are no problems occuring. When i use two channels (with the code below) the signals gets generated, but then matlab dont stops running and i can unly quit when closing matlab.
I am very grateful for help
0 commentaires
Réponses (1)
Sai Deepesh Pokala
le 8 Juin 2018
When you install MATLAB, there is a cap on the RAM that it is allowed to occupy. Therefore, if your code involves creating temporary high-dimensional arrays or matrices, chances are it might reach that limit. Try eliminating unwanted loops or assignments. Good luck!
0 commentaires
Voir également
Catégories
En savoir plus sur Data Acquisition Toolbox Supported Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!