Resetting FFT (HDL Optimized) in Simulink
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am using the HDL optimized FFT block in Simulink as the core of a frequency estimation system to be implemented on an FPGA. I am receiving bursts of BPSK modulated data, and so need to determine the frequency offset of each burst. What I want to do is reset the internal state of the FFT after each burst (which I detect with a separate energy detection block) - which I've tried with both a resettable subsystem and the actual reset port on the FFT block - but neither successfully reset the FFT. Either the FFT will not update and continue to output the first frequency locked, or will reset to 0 and once again not update.
However, I know that the FFT itself (and the rest of the system) is working, as when I start the simulation before a burst, it properly determines the frequency.
0 commentaires
Réponses (1)
Alireza
le 13 Août 2018
You probably reset the core too early before the whole frame is out. Use the ENDOUT output signal of the FFT to time the reset.
0 commentaires
Voir également
Catégories
En savoir plus sur Transforms dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!