Unable to download noninlined S-function into Arduino-2560
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi, I am using "Simulink Support Package for Arduino Mega 2560 Hardware" and it works perfectly fine. Thanks for the support.
I would like to add a non-inlined sfunction. For this i have chosen the noninlined sfunction button inside configuration->code generation->interface pane, but i am unable to generate the code.
Thanks in advance
2 commentaires
Réponses (2)
Rolfe Dlugy-Hegwer
le 28 Août 2012
Try the following: # Press Ctrl+E. # In the Configuration Parameters dialog that opens, select "Code Generation" and then "Interface". # In the Interface pane, select the checkbox next to "non-inlined S-function".
1 commentaire
Eric Bott
le 9 Avr 2014
Hi Rolfe, I have a similar problem, but for the raspberry pi. I've tried using this solution, but it appears to invalidate the raspberry pi code deployment setup, after which the option to run the model in external mode disappears, and a dialog offering to automatically re-setup the code generation parameters for raspberry pi is again presented. If the dialog is accepted, then the non-inlined box is automatically unchecked, and run external is again offered. Is there perhaps a minor modification which I could make to a config file somewhere, to override the raspberry pi model deployment non-inlined s-function check, so as to enable running external on the pi with non-inlined s-functions? Best Regards, Eric
Murat Belge
le 10 Avr 2014
Non-inlined S-functions are not supported by Arduino, Raspberry Pi or LEGO EV3 / NXT support packages. You can only use inlined S-functions with these support packages.
0 commentaires
Voir également
Catégories
En savoir plus sur Modeling dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!