Shifting column with data

From the picture I would like to move everything from the column 2 between 120(degree) and 240(degrees), shifted one time to the left and shifted down one more time. Next, for column 3 between 240 (degree) and 360(degree), shift two times to the left and two times down.

Below is the code to the graph from the picture. I am not sure how to proceed. If you need clarification I can do so.

for i = 1:N
    if (TFx(i) == 0) && (TFy(i) == 0)
        if (sOnAngleH0(i)>=xBotEdge && sOnAngleH0(i)<=xTopEdge...
                && AngleHa(i)>=yBotEdge && AngleHa(i)<=yTopEdge)
            xi = ceil((sOnAngleH0(i)-xBotEdge)/[(xTopEdge - xBotEdge)/row]);
            yj = ceil((AngleHa(i)-yBotEdge)/[(yTopEdge - yBotEdge)/col]);
            jointBins(xi, yj) = jointBins(xi, yj) + 1;
        end
    end
end

Any help is most appreciated.

P.S. I need the data of the columns being shift to overlay on the other data points, after all the columns shift all the diagonal points all to be in 0 < x < 120 and 0 < y < 120.

Answer 1

[KSSV]

YOu may proceed some thinkg like this:

[X,Y] = meshgrid(1:10,1:10) ; 
Z = diag(1:9,-1)+diag(1:10)+diag(1:9,1) ;
Z = fliplr(Z) ; 

figure(1)
pcolor(X,Y,Z)
% to move this chunk 
[X1,Y1] = meshgrid(4:7,4:7) ; 
Z1 = interp2(X,Y,Z,X1,Y1) ;
% to this chunk 
[X2,Y2] = meshgrid(1:4,1:4) ; 
Z2 = Z ; 
Z2(1:4,1:4) = Z1 ; 
figure(2)
pcolor(X,Y,Z2)

[SugerCodeCude]

Thank you for you quick response,

I am testing the code you have provied, when I shift this it overlay the data or does it change and it replaces it with what has been shifted?

[KSSV]

Run the code and analysie it....I have replaced there....you can make necessary changes.

Answer 2

[SugerCodeCude]

The code works great, however I put in my jointBins and in a area to then move. I get a error

% to move this chunk 
[X1,Y1] = jointBins(4:7,4:7) ; 

because it is 10x10, error is

Insufficient number of outputs from right hand side of equal sign to satisfy assignment.

in my code the row = 10 and col = 10

and

xTopEdge = 360

xBotEdge = 0

yTopEdge = 360

yBotEdge = 0

[KSSV]

Your data will be:

x = linspace(0,360,10) ; 
y = linspace(0,360,10) ; 
[X,Y] = meshgrid(x,y) ; 

[SugerCodeCude]

Thank you for all you help!