Info
Cette question est clôturée. Rouvrir pour modifier ou répondre.
Problem with simscape model
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi everyone,
i'am a beginner with matlab and simulink, and for a thesis project i'am trying to set some simulations to have base results for the successive experimental tests.
In this specific case, i'am trying to simulate a very simple system, the will become more complex in the successive steps: a force source that is emulating a force given by a compression spring, and i have to verify if the spring force is enough to overcome a load, that is given by the other force source. In the middle i have a Loaded-Contact Translational Friction to simulate the load that i given by a torsional spring on my physical system.
When i try to simulate, i have the errors that are showed in the image, and i don't what is the problem. Could be related to a missing degree of freedom between the 2 sources?
4 commentaires
Réponses (1)
Nikhil Sonavane
le 9 Août 2019
From your model I understand that you have not connected any mass blocks to your Loaded Contact Translational Friction block. Without these mass blocks the Loaded Contact Translational Friction block becomes a mass less system and hence cannot converge. I suggest you add these blocks to your model and try again. I have attached the modified model file.
2 commentaires
Nikhil Sonavane
le 9 Août 2019
Attaching MATLAB R2018b version of your model. I have checked it for MATLAB R2018b version.
Cette question est clôturée.
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!