How to solve a problem during hardware setup 'Accelerometer data from Pixhawk'?
9 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I'm setting up the PX4 Autopilot support package with Pixhawk1.
I confirmed that building and uploading the firmware was successfully.
but I could not get accelerometer data after uploading the firmware such as below figure.
How can I solve it??
Additionally I've tried to run a model(px4demo_ADC) in external mode.
But I got similar errors related to connection with pixhawk.
Error occurred while executing External Mode MEX-file 'ext_comm':
Timed-out waiting for second connect response packet.
Component:Simulink | Category:Block diagram error
Unable to connect to the 'PX4 Pixhawk 1' target for 'px4demo_ADC'.
My environments are Windows 10 64bit, Matlab 2019a, Pixhawk1.
Réponses (3)
mehmet enes avcu
le 6 Fév 2020
Hi moon
I have problem like your problem
did you solve this problem
0 commentaires
islam dib
le 27 Fév 2020
In the hardware setup chose My board in not listed here
before that, found your fum version: enter in the qGroundControl ,
the pixhawk serie is detected there, and the fum version also. You can found your fum version whene you try to upload the firmware using Qground... (you found something like this: fum_v2 or fmu_v3 ...)
after determenation your fmu_version enter in the hardware setup: setect "" My board in not listed here""
then in "select Cmake configuration" chose your one (in my case fmu_v2): (chose defaut version)
follow the rest steps...
0 commentaires
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!