Using scatter3 in conjunction with setting axis limits draws at wrong coordinates
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
JP Schnyder
le 3 Déc 2019
Réponse apportée : Navya Seelam
le 6 Déc 2019
I try to plot a point at a specific 3d coordinate. But if I use set(gca, 'XLim' or 'YLim' or 'ZLim',...), the point is plotted at a wrong position in the 3D graph. Below, I put the code without set(gca ...) together with the plotted result. Then, I add code using set(gca ...) with the result.
close all
figure
p0 = [0 0 0];
p1 = [0 0 0];
plot3(p0,p1,p1)
grid
xlabel('x')
ylabel('y')
zlabel('z')
hold on
x = 1
y = 3
z = 9
scatter3(x,y,z)
%plot3(x,y,z,'*')
close all
figure
p0 = [0 0 0];
p1 = [0 0 0];
plot3(p0,p1,p1)
grid
xlabel('x')
ylabel('y')
zlabel('z')
lim = [0 10];
tick = (0:1:10);
set(gca,'XLim',lim)
set(gca,'XTick',tick)
set(gca,'YLim',lim)
set(gca,'YTick',tick)
set(gca,'ZLim',lim)
set(gca,'ZTick',tick)
hold on
x = 1
y = 3
z = 9
scatter3(x,y,z)
%plot3(x,y,z,'*')
Using plot3 instead of scatter gives the same results.
0 commentaires
Réponse acceptée
Navya Seelam
le 6 Déc 2019
Hi,
The point is being plotted at right position. Try rotating the plot to make sure the point is at right position
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Surface and Mesh Plots dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!