Programing C2000 F28069M using Matlab simulink

I am using malab2019b simulink version to program the c2000 f28069m development kit

I do my project on 3 phase inverter and I need to synchronize the inverter with the grid and control the output voltage of the inverter. I did my simulation and it run correctly in Matlab. the switching frequency that I need is 20kH for controlling . But when I upload this to the board it can only work for 2.5kH only. If the switching frequency increased than 2.5kH it gives a error. (I change the sampling time according to the switching frequency.).

Other problem is I am using a ADC block to give the input(Voltage measurement) input signal is distorted more. I attach some pictures of my output and simulation.

in hear sample time is 0.0001s

******

This is my Input sine wave shows in Matlab Scope

*****************************************************************************************

I incresed sample time to 0.00001 and then this error occur

plz give me a solution for this two problems

Thank you.

Answer 1

[Venkatesh Chilapur]

Hi,

We have motor control example using ePWM block which is more efficient way to produce the 3phase output than GPIO DO. Here is the link to the page:

Motor Control TI C2000

You may also find the video handy when exploring these models.

https://www.youtube.com/watch?v=wxYTLbYfBP0

Regards,

Venkatesh C

Answer 2

[Antonin]

Hi Damsith Wasala,

This is a logging issue. Your ADC is fine, External mode is not able to log at these rates.

Please take a look at the answer I provided on this page:

https://www.mathworks.com/matlabcentral/answers/353939-can-simulink-use-ti-c2000-launchxl-f28027f-or-f2808-to-monitor-a-analog-signal-200khz

If you want to log at 20kHz, I suggest that you use the technic descirbed as 2-model approach.

I hope it helps,

Thanks,

Antonin.