Simulink Fuel Cell Stack - Hydrogen & Oxygen Utilization
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Within the Simscape Fuel Cell Stack Block, in the subsystem Uf calculator, 2 functions are used are labeled H2 Utilization Fuel Flowrate and O2 Utilization Air Flowrate.
These then connect to switches to determine whether to use the nominal utilization value for H2 and O2 respectively. However the output value of these functions is not a utilization value ie) % or decimal, but seem to be more inline with flowrate values.
Why is it that a switch is then used to determin if the nominal utilization value is used over the function output?
0 commentaires
Réponses (1)
Joel Van Sickel
le 17 Août 2021
Hello Matthew,
this is a case where the model behaves differently depending on certain choices made in the mask of the component, so you are essentially looking at multiple versions of a model, as in once place. This can make it a bit more confusing to understand what the model is doing but makes the model more useful for different parameterizations and use cases. The values from these blocks are not utilization, but flow rates.
Regards,
Joel
0 commentaires
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!