How to build a voltage compensation loop for Buck PCM
8 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I recently learned peak current method to control buck converter. After learning the theoretical knowledge, I set up a simulation model based on Simulink. The parameters are as follows:
Vin=24V Vo=12V
fs=50Khz Pn=24w
The output voltage is stabilized at 12V and the output current is 2A through PI compensation ring. Among them, the instruction current is the superposition of the slope compensation function and the error compensation network. At rated load, the inductor current tracks the command current in the transient process, reaching 9A. The current ring doesn't work. Please help me to see where I made a mistake.
Thank you very much!!
Figure 1 Buck Converter
Figure 2 peak control loop
Figure 3 blue line-Vo yellow line-Io
0 commentaires
Réponses (0)
Communautés
Plus de réponses dans Power Electronics Control
Voir également
Catégories
En savoir plus sur PCM dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!