Engine Speed controller Simulink
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello,
I have been using Engine Speed PI Controller as an example, but I could not understand the equation given in Throttle Angle subsystem i.e. 2.821 - 0.05231*u + 0.10299*u*u - 0.00063*u*u*u
So is it possible to help me with this situation on what are these actual values which are considered above does specify it ?
Thank you for your support.
regards,
Vishal
0 commentaires
Réponses (1)
Ryan G
le 5 Nov 2012
Modifié(e) : Ryan G
le 5 Nov 2012
The entire subsystem represents a calculation of the mass flow rate. You can find the equation on the Modeling Engine Timing page.
What you posted represents f(theta) and where u=theta. I haven't read the paper cited in the link above, but I would guess that equation was developed to fit test data based on the description.
0 commentaires
Voir également
Catégories
En savoir plus sur Automotive Applications dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!