Effacer les filtres
Effacer les filtres

How can I generate Arbitrary PWM with specific pattern on C2834x DSP?

2 vues (au cours des 30 derniers jours)
Ahmed Khamis
Ahmed Khamis le 15 Juin 2020
Commenté : Ahmed Khamis le 14 Juil 2020
Hello.
I am trying to generate a signal with same width as in figure on 2834x DSP using c2000 support package. Unfortunately ePWm modules CANNOT be used and the only option that I have got are the GPIO pins. I tried repeating sequence stair block and it worked fine When sampling time was 1/(3*140000). However, when decreasing the samplig time to 1/(12*140000), the PWM pin behaviour becomes awkward and the pins is either always ON r always OFF. I tried modifing the step size to be lower value 1/(120*140000), but it also gave this awkward behaviour.

Réponses (1)

Venkatesh Chilapur
Venkatesh Chilapur le 2 Juil 2020
Hi,
Here is an idea:
I set the solver to 0.01step time in above case.
HTH,
Regards,
Venkatesh C
  1 commentaire
Ahmed Khamis
Ahmed Khamis le 14 Juil 2020
This doesn't work, I even checked the output of "rem" block, it is zero all the time. Anyways, I doubt that this logic would output a signal with same pattern shown in scope in my original question.

Connectez-vous pour commenter.

Catégories

En savoir plus sur C2000 Microcontroller Blockset dans Help Center et File Exchange

Tags

Produits

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by