If else if loop
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello all, I am trying to make a MATLAB function block in Simulink where in I need a specific spring force (Spring rate x Displacement) for a specific displacement signal. Following is the Simulink figure and the corresponding code in the block.
function Spring_Force = fcn(displacement)
if (0 <= displacement <= 15) % Stroke
Spring_Force = 10*displacement;
elseif (16 <= displacement <= 100) % Stroke
Spring_Force = 18*displacement;
else
Spring_Force = 14*displacement;
end
__________________________________________________________________________________________________________________________
The problem: The output is always the first statement i.e. - Spring_Force = 10*displacement; even if the displacement signal varies above 15 as specified. It does not consider the elseif and else statements at all. There is no error shown. If I re-write the first statement as Spring_Force = 0*displacement, the output is 0 for that input signal. Can anyone please help on this?
Thank you very much.
0 commentaires
Réponses (1)
madhan ravi
le 16 Juin 2020
function Spring_Force = fcn(displacement)
Spring_Force = (0 <= displacement <= 15) .* 10*displacement + ...
(16 <= displacement <= 100) + 18*displacement + ...
(displacement > 100) + 1 * displacement;
end
Voir également
Catégories
En savoir plus sur General Applications dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!