How to get the coefficients from FDA Tool block (Simulink) using Matlab Command?
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Is it possible to extract the coefficients from FDA Tool block (Simulink)to Matlab workspace using Matlab Command? For a special reason, I would not like to use Menu => File => Export. I can use get_param to get value from most of blocks but not FDA Tool.
Also, is it possible to set the parameters of the FDA Tool block (Simulink) from Matlab. For example, - Response Type = Low Pass - Design Method = FIR - Window - Filter Order = 10 - Options = Window = Hann - Frequency Spec = Fs = 48k, Fc = 10k ?
Again, set_param would do in most blocks but FDA, I could not.
3 commentaires
Fangjun Jiang
le 15 Avr 2011
I can't find it. What version of Matlab are you using? What is the full name of the block?
Réponse acceptée
Rob Graessle
le 15 Avr 2011
If you right-click on the Digital Filter Design block (FDATool block) and 'Look Under Mask', you will see that the block contains a Digital Filter block. Do a get_param(gcb, 'ObjectParameters') on this block and you will be able to see the coefficients.
I do not think it is possible to use set_param to change the FDATool values from MATLAB.
2 commentaires
Kaustubha Govind
le 15 Avr 2011
To add to Rob's answer: fdatool is supposed to be an interactive MATLAB GUI, which is basically invoked by the FDATool block. Since the GUI itself does not directly correspond to a block, you cannot perform set_param and get_param on it. However, you can generate MATLAB code from the given parameters (File->Generate MATLAB Code), and then change parameters there to change filter coefficients.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Array and Matrix Mathematics dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!