Cannot boot RTTarget-32 from Virtual 8086 mode
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi, when took an example about xPC Target Stand Alone in matlab help 2012b, i took the steps in the help, and the only different was tha i had not edit the autoexec.bat located in the C:\ with dos commands, i edit it in xp with txt in xp syttem insteard, and when i finished transfering file from the host computer to the target computer and editing the autoexec.bat. i reboot my target computer in dos system, but the system returned some information as below: "RTTarget-32 DOS Boot Utility 5.23(c) 1996,2011 On Time Informatik GmbH Cannot boot RTTarget-32 from Virtual 8086 mode"
and the target computer had not run the model i transfered to it, could anybody give me some favour about these prombles, or is there anybody who met the same problems.
3 commentaires
Réponses (0)
Voir également
Catégories
En savoir plus sur Multicore Processor Targets dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!