How can I check what is the actual measurement being done by 'MinorAxisLength' using 'regionprops' command?

1 vue (au cours des 30 derniers jours)
I would like to know along what path on my input image the minor axis is being considered? How could I check this.
I am ctually trying to measure the width of segmented cardiac chambers.
If the chambers extracted are not horizontal and are aligned at a particular angle or the chambers extracted are skewed I would like to check what eactly is the 'Minor axis' being measured when I use 'MinorAxisLength' parameter in regionprops command since the length obtained does not coincide with the manual measurements i make using imtool.
Any assistance in this matter would be gratly appreciated.
Thanks in advance!!

Réponses (0)

Produits


Version

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by