Force plate zero offset
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have collected data from a force plate with the use of matlab. But initially, the signals of 6 channles were set slightly below or above the zero.
I want to know how to set it zero offset with the use of matlab code.
2 commentaires
Réponse acceptée
Jiro Doke
le 28 Avr 2011
Typically, you would do a reference measurement (with no load on the force plate). Take that measurement and compute the average (mean) of it. Then after taking your actual measurements, subtract the average you computed before with the no-load condition.
5 commentaires
Jiro Doke
le 8 Mai 2011
I'm not sure that's physically possible. You have to physically have nothing on the forceplate for the "no load" condition, and then do the experiment. The way I used to do the experiment, was to record the no load condition at the beginning of the test and store the data. Then after doing all the experiments, I postprocess by subtracting the no-load data from all of my test results. Another way is to run the test with no load for the first few seconds. Then when you post process, take the mean of the first few seconds and subtract it from the rest of the experimental data.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Biomechanics dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!