Need help Linearizing a Simulink Model?
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello,
I need help linearizing a non-linear switching variable frequency variable voltage power supply in order to implement the controls.
So far i have tried operating points, linmod, dlinmod, tfestimate, frestimate but no luck. My results always show zero response for step or bode plots. State space results show an A matrix but zero for B,C,and D. Any more suggestions I can try? Are some simulink models not able to linearize? (This model includes digital logic and flip-flops etc.) However, the overall relationship is a setpoint sinusoidal voltage to an output voltage, SO I believe there should be a way to find this relationship.
Please help!
2 commentaires
Arkadiy Turevskiy
le 24 Fév 2011
Some models will linearize to zero, when they have things like switching (pwm type) or conditionally enabled subsystems.
frestimate should be able to help in this case. Would you be willing to e-mail your model so I could take a look at it?
Erman Korkut
le 25 Fév 2011
Frestimate usually takes a couple of tries to come up with the right input signal parameter values such as amplitudes, sample times and frequency values. It is always helpful to look at your simulation results using frest.simView command. You can check this demo on how to use frestimate and frest.simView to inspect the estimation/simulation results:
http://www.mathworks.com/products/simcontrol/demos.html?file=/products/demos/shipping/slcontrol/scdenginepad.html
Another tool that might be helpful to you is system identification toolbox.
As Arkadiy mentioned, I would be happy to look at your model if you can send it.
Réponses (1)
Laura Proctor
le 17 Sep 2012
Modifié(e) : Laura Proctor
le 17 Sep 2012
Posting the comment from Erman Korkut as a solution:
Frestimate usually takes a couple of tries to come up with the right input signal parameter values such as amplitudes, sample times and frequency values. It is always helpful to look at your simulation results using frest.simView command. You can check this demo on how to use frestimate and frest.simView to inspect the estimation/simulation results:
Another tool that might be helpful to you is system identification toolbox.
As Arkadiy mentioned, I would be happy to look at your model if you can send it.
0 commentaires
Voir également
Catégories
En savoir plus sur Offline Frequency Response Estimation dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!