Level 2 S Function
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
How to set the size of the output ports in level 2 S function to dynamic size.. ??
1 commentaire
MarkB
le 7 Juin 2011
Just to make sure, would you please clarify whether you mean "dynamic" or "variable size"? The two sound quite similar, but aren't the same:
Dynamic: the port can accept a variety of possible port dimensions, but whatever dimensions are accepted are finalized and constant for the rest of the simulation.
Variable sized: These have a worst-case dimension specified, either hard-coded, or resolved in the same way as dynamic dimensions above, but during simulation,it is possible that only a subset of the worst-case dimension is used.
Réponses (2)
Kaustubha Govind
le 11 Mai 2011
Have you tried using:
block.SetPreCompOutPortInfoToDynamic;
In your setup function? I think that should do it.
"... assign a value of -1 to the dimensions. In this case, you can implement the SetInputPortDimensions method to set the dimensions during signal propagation."
You can extend this information to the output port and set dimensions to -1 in the setup and implement SetOutputPortDimensions.
2 commentaires
Kaustubha Govind
le 18 Mai 2011
Have you tried the second technique of setting the output port dimensions to -1 and implementing SetOutputPortDimensions?
Voir également
Catégories
En savoir plus sur Configure Block Features for MATLAB S-Functions dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!