PID in ThingSpeak code
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I tried to write pid code in thingspeak app matlab analysis, but I faced some problem. Can anyone help?
sensed_output = thingSpeakRead(readChannelID), control_signal;
setpoint=23;
Kp = 1;
Ki = 1;
Kd = 1;
T= 5000;
double total_error, last_error;
int max_control=100;
int min_control=0
double error = setpoint - sensed_output;
total_error += error;
if total_error >= max_control
total_error = max_control;
elseif total_error <= min_control
total_error = min_control;
else
total_error = total_error;
end
double delta_error = error - last _error;
control_signal = Kp*error + (Ki*T)*total_error + (Kd/T)*delta_error;
if control_signal >= max_control
control_signal = max_control;
elseif control_signal <= min_control
control_signal = min_control;
else
control_signal = control_signal;
end
last_error = error;
analyzedData = control_signal;00
%% Write Data %%
thingSpeakWrite(writeChannelID, analyzedData, 'WriteKey', writeAPIKey);
1 commentaire
Réponses (1)
Christopher Stapels
le 25 Jan 2021
I'd suggest you have a look at the MATLAB onramp. Its a two hour introduction to MATLAB fundamentals, I think you would find it really helpful. Once you have that down, I think writing the PID code will be much easier.
0 commentaires
Communautés
Plus de réponses dans ThingSpeak Community
Voir également
Catégories
En savoir plus sur Prepare and Analyze Data dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!