Alternately zooming and editing a figure
7 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Todd Welti
le 7 Mar 2021
Commenté : Todd Welti
le 31 Mar 2021
Has anyone found a solution to the problem that the edit model and zoom mode are mutually exclusive and buttons far apart? I spend about half my time zooming in and out and then going into edit mode and back into zoom mode. The edit button is all the way over on the left, and the zoom button is over on the right. I tried to set up a keyboard shortcut for switching edit-off-zoom-on, and the reverse but couldn't figure out how.
0 commentaires
Réponse acceptée
Pratheek Punchathody
le 31 Mar 2021
Modifié(e) : Pratheek Punchathody
le 31 Mar 2021
As per my understanding, you are using the Zoom tool in the axes bar of the figure window and Edit menu from the menu alternatively. One work around to reduce the time of work during the switch between these two options is to enable the property inspector.
Following steps would help you to enable this,
View>Property inspector
By enabling this Property inspector will be populated along side of the Figure window.
Configuring and layouting the window according to the need will help you in minimizing the time to navigate between the edit and zoom mode.
Hope this helps..!
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Data Exploration dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!