Initializing GUI through GUIDE

I am trying to learn making GUIs in matlab using guide. Upon, opening a GUI layout using guide command, I understand that a new figure shall be created and it should be saved to start with.

However, whenever I attempt a save I get an error as shown in the screenshot in the following link: https://dl.dropboxusercontent.com/u/60477323/error%20message.jpg

Can someone please suggest what is going on.

Answer 1

[yeshwanth manhcuri]

try to reinstall guide n luk in help....

[Santosh]

I went ahead and installed a new version of Matlab (R2013a) and the problem disappears.

Answer 2

[Vishal Rane]

Your GUI fig file and the corressponding mfile are probably out of sync. Open a blank gui and try saving it as it is.

[Santosh]

I have tried that, I get the same error message.

Answer 3

[Santosh]

I have identified the real culprit.

The real culprit was the conflict between the assert.m script built in matlab and assert.m script that was part of a submission I had downloaded from FILEX.

-- Santosh