Simscap Scope shows wrong data.

I am simulating an RL Circuit.

when i take simulation time 10 ses, the graph on scope is nonsence.

if anyone know, how to fix it. please let me know.

Best Regards.

[Pemendra Kumar Pardhi]

please provids details, if it is possible please attached screenshot of circuit in mathwork

[Farhad Barati]

Hello Muhammad,

Try to reduce the step-size to get an accurate result.

[Mohammadreza Adib]

hi

open scope setting and uncheck first line in the last tab. it's about storing point. besides it's better to attache a photo to show your problem.

Answer 1

[Joel Van Sickel]

Hello Muhammad,

this issue is likely not the scope, but the simulation results. The easiest explanaion of why the results don't make sense is that too large a time step is being used to plot them well. The results can actually be correct, but look wrong because of the large time step. Please set the maximum step size to a small value and your scope data may clean up. If that doesn't work, then something is probably wrong with the model or solver settings such that the simulation is not converging.

Regards,

Joel