How to set subplots same size
188 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Jurrien Plijter
le 22 Juil 2021
Commenté : Zhongzheng Wang
le 28 Mar 2022
Hi all,
I would like to get my subplots the same size. It now defaults to the first picture below, but I would like to have it as in the second picture (created by manually sizing the figure). How to modify my code? Thanks for the help. The search function did not answer my question.
clear all; clc;
dt = 0.01;
time = 0;
iter_limit = 1000;
iter = 0;
next_initial = [0 0]; % [angle [rad] , angular velocity [rad/sec]];
ode45_check_initial = next_initial;
torque = 0;
torque_setting = 2;
x1_save=[];
x2_save=[];
time_save=[];
torque_save=[];
h=figure(1);
subplot(1,2,1); hold on;
fig_animation=plot(0,0,'k',0, -1,'.k','MarkerSize',20);
axis equal;
xlim([-1.5 1.5]);
ylim([-1.5 1.5]);
xlabel('x [m]');
ylabel('y [m]');
fig_rectangle=rectangle('Position',[-0.05 -0.05 0.1 0.1],'FaceColor','k');
subplot(1,2,2); hold on; grid on;
fig_timeplot=plot(0,0,'b',0,0,'r',0,0,'k');
hold on;
xlim([ 0 iter_limit*dt]);
ylim([-1.5*pi 1.5*pi]);
xlabel('time [s]');
ylabel('amplitude [-]');
legend('angle [rad]','angular velocity [rad/s]','applied torque [Nm]');
hold off;
1 commentaire
Réponse acceptée
Yazan
le 22 Juil 2021
Because you are requesting to use the same length for the data units along each axis when you specified
axis equal
Matlab will not provide axes of the same width and height. A simple solution is to remove the line above.
6 commentaires
Yazan
le 23 Juil 2021
Modifié(e) : Yazan
le 23 Juil 2021
Then a very simple solution is simply to increase the size of your figure, as you are doing manually by the mouse.
When you initiate your figure, use the following for example:
h = figure('Units', 'normalized', 'Position', [0.12 0.35 0.68 0.5]);
Generally, you can control the position, height, and width f the figure, and also axes. Read here and here. If you want to force two axes to have the same height and width, you can use the following:
% ax1 and ax2 are axes handles
ax1.Position(3:4) = ax2.Position(3:4);
Matlab however will override this command if this size of your figure does not allow having axes of the specified size.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Axis Labels dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!