Error when using spice model for MOSFET for Basic Buck w/ PI control
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Christine Page
le 27 Juil 2021
Réponse apportée : Yoshi Minagawa
le 28 Juil 2021
Hi all. I'm trying to simulink a buck converter w/ PI control with a MOSFET SPICE model with a generated block created from a spice netlist. I keep getting thrown a error that I don't really understand. Below is the picture of my model and the error.
This is just a basic buck converter with PI control, so the only thing I was thinking was the problem was the MOSFET, but it keeps highlighting the simulink-ps converter as the issue which I don't really understand.
I have attached my files as well for feedback. If someone could explain what is going on, that would be super helpful. Thank you.
For reference: Node 3 is the source, Node 2 is the gate, and Node 1 is the Drain.
0 commentaires
Réponse acceptée
Yoshi Minagawa
le 28 Juil 2021
Hi Christine,
When this error occurs, it maybe is valid to enable the filter of Simulink-PS Converter block. By enabling the filter, you can provide the derivatives needed for Simscape calculations. For details, please refer to the similar answer.
I hope this will help.
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Semiconductors and Converters dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!