Installation et configuration
Avant de commencer à utiliser Communications Toolbox™ Support Package for Analog Devices® ADALM-Pluto Radio, vous devez :
Installer ce support package en suivant les instructions de Install Support Package for Analog Devices ADALM-PLUTO Radio.
Établir la communication entre l’ordinateur hôte et la radio en suivant la procédure décrite dans Guided Host-Radio Hardware Setup (Guide de configuration du hardware radio hôte).
Fonctions
configurePlutoRadio | Configure ADALM-PLUTO radio firmware |
findPlutoRadio | Report information about attached radios |
sdrdev | Create radio object for specific radio hardware |
Classes
comm.SDRDevPluto | Create object for Analog Devices ADALM-PLUTO radio |
Rubriques
- Supported Hardware and Required Software
Get an overview of supported hardware and required software products.
- Install Support Package for Analog Devices ADALM-PLUTO Radio
Install the Communications Toolbox Support Package for Analog Devices ADALM-Pluto Radio.
- Guided Host-Radio Hardware Setup
Follow an automated hardware setup process to establish communication between the host and the radio hardware.
- Manual Host-Radio Hardware Setup
Follow a manual hardware setup process to establish communication between the host and the radio hardware.
- What to Do After Installation
After you have successfully installed the support package, you can do any of the following:
- Setup for Two Radios Connecting to One Host
Set up two radio hardware devices connected to one host computer.
- Uninstall Support Packages
Uninstall the support package using the Add-On Manager.
Résolution des problèmes
Resolve issues encountered while installing or using the features of the support package.