Fitting Curve passing through zero using CFTOOL
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Giuseppe Naselli
le 16 Jan 2014
Modifié(e) : Mischa Kim
le 16 Jan 2014
Hi All,
below the data from a damper dyno test (attached). As you can see this shows some hysteresis.
I was interested in having only one curve passing basically in the middle (a sort of average between the bump and rebump stroke) I obtained this using the cftool (and help from the matworks answer:). In particular, I achieved that with the followings
% Create a smoothing spline fit with the parameter I specified
Fit_of_the_Data = fit(Velocity, Force, 'smoothingspline', 'SmoothingParam', 0.025)
% Create a variable with the point of the fit
Data_fitted = feval(Data_Fit,Velocity);
The fitting result is "more or less" fine (see below)
However, I wish my fitting curve to pass through zero . How can I do that?
Thanks in advance
G
0 commentaires
Réponse acceptée
Mischa Kim
le 16 Jan 2014
Modifié(e) : Mischa Kim
le 16 Jan 2014
Hello Giuseppe,
you could use a simple, brute-force approach to get a little closer: add a couple of (0,0) data points to the force and velocity vectors and re-do the curve fitting. If forcing the curve through (0,0) does make sense for your application is something you need to decide.
0 commentaires
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Interpolation dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!