Problem with Enable subsystem in simulink
4 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I am simulating a Switched reluctance machine having 4 phases. Each phase is an enabled subsystem enabled by control signals generated from angle feedback. The problem is that even though the control signal is a pulse waveform varying from 0 to 1, the enable signal inside the subsystem is always shown to be 1 (observed from 'show output port'). This means the subsystem is always being enabled.
I am unable to resolve this issue. Please help asap.
0 commentaires
Réponses (1)
Chandrasekhar
le 21 Mar 2014
Modifié(e) : Chandrasekhar
le 21 Mar 2014
The output of the enable subsystem holds the value even if the subsystem is disabled. If you want to reset the output value do as shown in figure below
Voir également
Catégories
En savoir plus sur Subsystems dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!