Pause a process, using a NI USB6008
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello, I have the following problem:
I have two sensors connected to a NI-USB6008 data acquisition device, and one analog output which turns on a flashlight.
The thing is that I need this flashlight to turn on a few seconds after the data is being received, and turn of a few seconds before the process ends.
I know that this device does not support clocked processes, because it has no timer inside, but is there a way that, by using pause or some similar command, I can control when the flashlight turns on and off?
Thanks in advance!
P.S.: I attached the script I'm using. Don't worry about the comments in spanish :)
0 commentaires
Réponses (0)
Voir également
Catégories
En savoir plus sur National Instruments Frame Grabbers dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!