Simulink : Arduino serial receive 1 byte to control pin13 led ON/OFF
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
hi everyone:
Forgive my poor English :)
i first met Simulink these days.and i played all examples in it.
i want arduino can do things below in Simulink;i don't know how to setup up serial receive block.
can someone teach me a little bit :)
-------------------------------
void setup() {
pinMode(13, OUTPUT);
Serial.begin(115200);
}
void loop() {
while(Serial.available() )
if(Serial.read() == '1')
digitalWrite(13, HIGH);
if(Serial.read() == '2')
digitalWrite(13, LOW);
}
0 commentaires
Réponse acceptée
Plus de réponses (1)
Sreeram
le 31 Juil 2014
Hi nt,
The easiest way to get to what you want is to add a Serial Receive block and add a comparator or a switch case block as you seem good for your logic at the output of the block to decide and then glow and LED.
I have attached a simple model snapshot that shows how to achieve a simple case !
Hope this helps
Thanks,
Sreeram Mohan
0 commentaires
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Produits
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!