bno055 System "uncalibrated"
13 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I was working with my adafruit bno055, and tried to interface it with matlab. I was able to interface both my Uno and my bno055 sensor. I followed the matlab's documentation page to calibrate the bno055 senor. and used the readCalibration status command to see how it went. I got this message on my terminal. I got the following message...
I also followed the offical matlab's tutorial on how to connect the bno055 with matlab in their website. The question is how do I get the system status to be calibrated ?. I also was able to get the sensor system to be fully calibrated using Arduino's IDE. So I know that I didn't recive a fauly bno055 senor.
3 commentaires
Réponses (2)
Gayatri Menon
le 13 Mar 2022
Hi
Have you tried the calibration steps as mentioned in the below doc
Thanks
Gayatri
0 commentaires
Germano Gallicchio
le 16 Mar 2022
Modifié(e) : Germano Gallicchio
le 16 Mar 2022
Have you found a solution? If not, try using the 'Adafruit/BNO055' library instead of the 'I2C'. Initially, I was getting the same error as you. Now I can calibrate the System to 'full'.
arduinoObj = arduino('COM7', 'Micro', 'Libraries', 'Adafruit/BNO055');
I am using MATLAB version 2020b. The 2021b version of the Arduino package does not include the 'Adafruit/BNO055' library.
0 commentaires
Voir également
Catégories
En savoir plus sur I2C Devices dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!