Converting Polyfit exponents to a power of e
1 vue (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have used polyfit to convert a raw data file of current and voltage for a diode to an equation for current = f(voltage) and plotted the equation with a very good fit of a plot of the raw data. I would like to convert the polyfit exponents to a power of e or exp(power). I have looked at MATLAB help for taylor or maclaurin and other related functions with no corelation on my part. Is there something in the tool boxes that will do this conversion?
0 commentaires
Réponses (1)
Walter Roberson
le 18 Sep 2011
I am not clear as to what you are trying to do. Suppose the polynomial was (say) x^3 - x^2 + x + 1, then what output would you expect, or at least what form of output?
Are you trying to convert a polynomial to a single exponential that is itself in polynomial form? If so then you could do a series expansion of the ln() of the polynomial. That will, however, suffer from the usual problems of series expansion: increasing inaccuracy as you get further from the point of expansion. You would need to decide what your target range was and what your target error limit was over that range, in order to figure out how many terms you needed.
0 commentaires
Voir également
Catégories
En savoir plus sur Polynomials dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!