currently i working on plotting a graph of rpm sensor on matlab but unfortunately when i run the plotting coding in Matlab it was failed.It said 'Warning: Unsuccessful read: Matching failure in format.' please help me,i dont know what is the problem
2 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
volatile int rpmcount = 0;
int rpm = 0;
unsigned long lastmillis = 0;
void setup(){
Serial.begin(9600);
attachInterrupt(0, rpm_car, FALLING);//interrupt cero (0) is on pin two(2).
}
void loop(){
if (millis() - lastmillis == 1000){ //Uptade every one second, this will be equal to reading frecuency (Hz).
detachInterrupt(0); //Disable interrupt when calculating
rpm = rpmcount * 60; // Convert frecuency to RPM, note: this works for one interruption per full rotation. For two interrups per full rotation use rpmcount * 30.
Serial.print("RPM =\t"); //print the word "RPM" and tab.
Serial.print(rpm); // print the rpm value.
Serial.print("\t Hz=\t"); //print the word "Hz".
Serial.println(rpmcount); //print revolutions per second or Hz. And print new line or enter.
rpmcount = 0; // Restart the RPM counter
lastmillis = millis(); // Uptade lasmillis
attachInterrupt(0, rpm_car, FALLING); //enable interrupt
}
}
void rpm_car(){ // this code will be executed every time the interrupt 0 (pin2) gets low.
rpmcount++;
}
0 commentaires
Réponses (2)
Image Analyst
le 11 Nov 2014
This is C or Java code, not MATLAB code. Use MATLAB instead.
4 commentaires
Walter Roberson
le 3 Juin 2018
You have the Arduino sending "RPM =" and "Hz=" but your MATLAB code is expecting only numeric values.
Osama Yassin
le 3 Juin 2018
Hi, Nazrin Zaini .. did get the solution about attachInterrupt function in matlab?
0 commentaires
Voir également
Catégories
En savoir plus sur MATLAB Support Package for Arduino Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!