- The pulse generator output can not connect with the power terminal of any elements (eg. Switch, inductor, capacitor, resistance and so on…). You can directly connect pulse generator output with the gate of IGBT.
- To connect IGBT collector terminal with line joining of inductor and diode, firstly remove all three collector connection, then connect collector of center IGBT with above line, then second one switch and then third one,
- For emitters also apply the above 2 rules.
how to connect converter circuit devices each other in matlab simulink ?
8 views (last 30 days)
Show older comments
Ali Zulfikaroglu on 19 Feb 2022
Answered: Pemendra Kumar Pardhi on 19 Feb 2022
I drawed dc dc converter circuit diagram. Red dashed lines shows matlab doesn't allow to connect that ports and I drawed red lines in paint to show I can't connect that ports each other . Why this happen ? How can I connect them each other ?
I added simulink file and paint file to show unconnected ports.
Generally I can't connect :
1) Pulse generator to resistor and resistor to IGBT gate ports
2) IGBT collecter ports to main circuit lines between inductor and diode
3 IGBT emitter port to ground port.
I hope you have got it.
It is fine in pspice. Same model can develop on matlab using sim electronic components.
More Answers (1)
Some ideas can be obtained from give model as given below link
Pemendra Kumar Pardhi (2022). Zeta Converter Based Led Driver Circuit (https://www.mathworks.com/matlabcentral/fileexchange/97984-zeta-converter-based-led-driver-circuit), MATLAB Central File Exchange. Retrieved February 19, 2022.
More Answers in the Power Electronics Control
Find more on Electrical Systems in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!Start Hunting!