How to make input in degree value with dwell time ?
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
KRISHAN THILAKARATHNE
le 10 Mai 2022
Commenté : Heshan Manu
le 19 Mai 2022
How to make the following statement in simulink ?
"enter a step move of 270 deg of the rotor, a dwell time of 8 seconds anda return step move"
Is this make from 'Step input', 'Sine wave' or other way ?
3 commentaires
Joel Van Sickel
le 19 Mai 2022
Modifié(e) : Joel Van Sickel
le 19 Mai 2022
yes, use this block and create a second one and subtract/add them together to create 2 transitions.
Réponse acceptée
Joel Van Sickel
le 18 Mai 2022
Modifié(e) : Joel Van Sickel
le 18 Mai 2022
Hello Rishan,
this is a fairly complicated question depending how far you have to take it. If you want to create a Simulink model that is just a value that is 0, then goes to 270, and then back to 0 after 8 seconds, you can use a source block to create that.
To do it more complicated would require using some sort of timer. An integrator with an input value of 1 is an easy to implement a timer in Simulink. When it's output is 8, 8 seconds have passed. You can also reset the integrator once your reached the relevant time. However, if you need to make an actual motor move, you have to then translate that command to actual motor commands, which is very dependent on what type of motor you are using.
Regards,
Joel
Plus de réponses (0)
Voir également
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!