Modelling a voltage controlled current source
9 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi!
I have a school project, where i need to simulate the blindig of protecion and sympathetic tripping defense problems. I'd like to model a current source that responds to the voltage drop caused by a fault. I'm using the controlled current source block for it. The constant block has the effective power value which gets divided by the rms value of the voltage so it should give me the current. My problem is that when i connect this block to my circuit it doesnt do anything. I'd like to ask what is the problem with my model?
1 commentaire
Réponses (1)
Joel Van Sickel
le 13 Juin 2022
This looks like it creates an algebraic loop. It's easier to do this type of modelling using simcape: https://www.mathworks.com/learn/tutorials/circuit-simulation-onramp.html
and use this block to model a dynamic load: https://www.mathworks.com/help/physmod/sps/ref/dynamicload.html
Regards,
Joel
0 commentaires
Voir également
Catégories
En savoir plus sur Electrical Sensors dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!