How to use I/O mode to control a servo motor?
3 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hello everyone, I am learning to use Arduino to control a servo motor. I successfully realized the this model, using external mode(run on the board), and the motor worked well. However, if I switch to I/O mode(run on the computer), the motor won't move at all. What other settings should I do?
I have another program that is too large to run on the board, so I want to try I/O mode first in this simple example. Any reply is welcomed. Thank you!
0 commentaires
Réponse acceptée
Arun Kumar
le 3 Juin 2022
Hi Cong Sun,
Not all the block support connected IO mode.
The blocks that support this IO mode are listed in the following page:
Other blocks which are not listed in this page will output 0s if you try to run in connecte IO mode.
Hope this helps!
Thanks,
Arun
6 commentaires
Arun Kumar
le 24 Juin 2022
Hi Cong Sun,
Changing of PWM frequency is not supported in Connected IO mode.
Plus de réponses (0)
Voir également
Catégories
En savoir plus sur Arduino Hardware dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!