simulink model of wind turbine lqg regulation does not work properly
5 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I have simulated the following block diagram with consists of a wind turbine state space with kalman filter, full state feedback and full state observer suggested by an article which I uploaded.
I don't know why I don't get the same output as the article! This is my simulink simulation:
This is my output:
This is the output in the article:
Also I'm not sure about where should I put the wind speed? I would really appreciate if you could help. I have attached my simulink file and the article.
0 commentaires
Réponses (1)
Sam Chak
le 1 Août 2022
I suspect that the instability is caused by the signs in these two summation blocks:
If you look into the closed-loop system, the feedbacks are of minus signs.
I guess you tried to follow the LQG block diagram in Fig. 1, but sometimes, some publications contained errors and the production crew were unable to fix the technical-related matters. Moreover, the paper has only one author.
Voir également
Catégories
En savoir plus sur Wind Power dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!