Hardware settings, replacing the C2000 hardware board gets an error

I got an error when I changed the hardware board to 2837xD in the hardware settings

The error is as follows：

创建 "配置参数" 对话框时出现意外错误。原因可能是您的 MATLAB 路径中的函数遮蔽了内置 MATLAB 函数

函数或变量 'matlabshared.target.tic2000.getInstallSpPkgMsg' 无法识别。

file: F:\matlab2022a\toolbox\target\codertarget\+codertarget\+utils\getTargetHardwareDetailWidgets.p

name: getTargetHardwareDetailWidgets

line: 0

[Keerthana Ramesh]

Hi,

To work around the issue and use the features from the Embedded Coder Support Package, set the below model parameters at the command line:

First, set your hardware board:

>> set_param(gcs,'HardwareBoard', 'TI Delfino F2837xD')

Then, enable the Embedded Coder Support Package feature set for your model:

>> set_param(gcs,'HardwareBoardFeatureSet', 'EmbeddedCoderHSP')

If this does not work, may I please know the MATLAB version you are using?

Thanks,

Keerthana

[Xiaohu Li]

Thanks for your answer! I have solved this problem. By adding the hardware support package "SoC Blockset Support Package for Texas Instruments C2000 Processors"! Previously I only installed "Embedded Coder Support Package for Texas Instruments C2000 Processors"

[昊天]

I encounted this problem too when I chose hardware as 2837xd. But unluckily, these solutions didn't work. My Matlab version is 2022b.

[昊天]

Further, it seems that problems occur only when 2837xd is chosen. I did this trial, and the other is Okay.