Matlab2022a生代码最后报错：The terminate function is required by rt_main.c

[波]

有大神吗？请教

Answer 1

[Tushar]

Hi,

The error message "The terminate function is required by rt_main.c" usually indicates that there is a problem with the generated code from MATLAB.

This error can occur if the code generation process did not complete successfully, or if there are issues with the generated code itself.

To resolve this error, you can try the following steps:

1. Check that your MATLAB installation and license are up-to-date and valid.
2. Check that your system meets the requirements for running MATLAB 2022a.
3. Re-run the code generation process and ensure that it completes successfully without any errors.
4. If the problem persists, try generating the code with a different configuration or code generation settings.
5. If none of the above steps work, contact MathWorks support for further assistance.

Additionally, you can try to manually add a terminate function to your code. The terminate function should be called when the simulation is stopped or when an error occurs, and it should clean up any resources that were allocated during the simulation.

For example, if you are using Simulink, you can add a terminate function to your model by right-clicking on the model and selecting "Model Properties", then selecting the "Callbacks" tab and adding a TerminateFcn callback.

I hope this helps you to resolve the issue.