Failed to "Tune and Monitor" the CAN Communication Protocol model in MATLAB/Simulink for TI Delfino F28379D

I am having an issue with the tune and monitor of the simulink model which is based on the CAN module for the TMSF28379D C2000 processor. I am implementing the MATLAB example given on the MATLAB site as follow:

open_system('c28x_CAN_comm.slx');

When I Buid & Deploy this model, it runs but when I try to Tune and Monitor it, it doesn't work!

The error it show is as below:

Can Someone help me in this regard?

[Uzair Amin]

I want to monitor the CAN signal (send & receive) status in a real time. If there is another solution, let me know. Thanks.

Answer 1

[Abhinav Aravindan]

Hi Uzair,

I assume you are trying to run the example “CAN Communication Using eCAN Blocks” using the “TI Delfino F28379D” board. In the output provided, it appears that a different file with the name “CAN_Device_v2” is being built and not the example file “c28x_CAN_comm.slx”.

To open the example, you may utilize the following command:

openExample('texasinstrumentsc2000/CANCommunicationUsingECANBlocksC2000Example') 

To set the Hardware board to “TI Delfino F28379D LaunchPad”

1. Navigate to Configuration Parameters > Hardware Implementation > Hardware board
2. Set the “Feature set for selected hardware board” to “Simulink or Embedded Coder Hardware Support Package”
3. Proceed with the steps mentioned in the documentation below:

https://www.mathworks.com/help/releases/R2021b/supportpkg/texasinstrumentsc2000/ug/ECAN-example.html

For MATLAB R2021b, in addition to the “Embedded Coder Support Package for Texas Instruments C2000”, you will also require the “Vehicle Network Toolbox”.