is it possible to achieve Transceiver with communication toolbox system objects for usrp ?

i would like to know that if we can achieve Transceiver using Communications Toolbox Support Package for USRP Radio, precisely with comm.SDRuTransmitter and comm.SDRuReceiver?

if yes, how? what i actually want that transmission is keep going on while usrp starts receiving.

executing one after one will initiate the receiver to receive only when transmission is completed and that is not what is required.

p.s.- i can use Wireless Testbench Support Package for NI USRP Radios (transmit and capture) for making usrp x310 act as transceiver as following.

transmit(bbtrx,y,"continuous");

pause(0.5);

rx_sig = capture(bbtrx,milliseconds(0.01));

Answer 1

[Prathamesh]

Hi,

Yes, it is possible to achieve Transceiver with communication toolbox system objects for usrp.

Steps to achieve transceiver are:

1. Configure and control USRP radios from MATLAB.
2. Transmit and receive signals using USRP radios.
3. Implement custom communication algorithms in MATLAB and deploy them to USRP hardware.

Please refer to the following documentation to get more information on Communications Toolbox Support Package for USRP Radio:

https://in.mathworks.com/help/supportpkg/usrpradio/getting-started-with-communications-system-toolbox-support-package-for-usrp-radio.html

Also refer to the following example which implements transceiver with USRP Hardware.

https://in.mathworks.com/help/supportpkg/usrpradio/ug/family-radio-service-frs-full-duplex-transceiver-with-usrp-r-hardware.html

Answer 2

[Ritesh Chandra Tewari]

Hey Nadim can you share your email id. I am also working on similar project. we can discuss.

[MOHAMMAD NADIM]

If you have any specific question, you can ask here, that way, it will reach to large audience.

[Ritesh Chandra Tewari]

I have some doubts about Labview. I am using usrp 2954 and trying the simple streaming example. In the example radar is working as a continuous wave. I want to customize the example to a fmcw radar and record the data. I am new to Labview, so can you help?