TI Delfino 28379F and BOOSTXL-3PhGaNInv with sensorless BLDC Motor no motor signals

Hello everyone,

i am trying to run the above mentioned setup. When i build and deploy the software to the target hardware i dont get any errors. I also tried to run a simple programm with blinking LEDs to ensure that the Hardware is communicating with the board. I am using the official Matlab software to run a sensorless Motor (mcb_open_loop_control_f28379d). Also i am using a 14.8 Battery to supply the Boost XL Inverter. For the host serial setup, host serial receive and transmit i used the same com port of the TI Delfino.

Any help would be appreciated.

Answer 1

[Ananth kumar]

This example should work out of the box. Please check your hardware individually, serial communication, ADC read, PWM. Or try the same with other set of hardware if you have.

But the shipping example is expected to spin the motor.