MATLAB 2022a and MASC ADAMS View 2018.1 Simulation

I have created control plant from MSC ADAMS view. When I run the simulink model, it automatically close. Can you help me to figure out?

Answer 1

[Sarthak]

Hi Vishal,

As per my understanding, if Simulink is closing automatically, it usually indicates there is an error or exception occurring during the simulation.

The error could be occurring due to multiple reasons. Here are a few steps you can take to diagnose and resolve the issue:

• Check the model configuration and verify all necessary parameters are defined in valid range.
• When Simulink closes, it may display an error message before closing. Try to understand the cause of error and fix the issue.
• Try setting the debug execution mode on which is likely to resolve the issue if the crash is because of conflicting libraries.
• Use breakpoints and other debugger tools in Simulink to debug your model. It should help in identifying any issues or unexpected behaviours in the model.

Please refer to the following documentations for more information on diagnostics and debugging.

https://www.mathworks.com/help/simulink/ug/diagnose-simulation-errors.html

https://www.mathworks.com/help/simulink/simulation-stepper.html

[Vishal Naik]

Thank you. I solved it.