error while build deploy and start the model tc4x_8ledsBlinky

when i build deploy and start the model tc4x_8ledsBlinky follow the illstrucation https://ww2.mathworks.cn/help/supportpkg/infineonaurix/ug/getting-started-led-example.html

Required Software

Launch hardware setup and install the following third-party tools. For more information, see Supported Hardware and Required Software.

• iLLD for TC4x family
• TASKING SmartCode for TriCore
• Infineon MemTool

Required Hardware

To run this example, you will need the following hardware:

• Supported Infineon AURIX TC4x board (STD or COM)
• USB cable

i have the hardware and software ,and the PINOUT was configured as COM ,i don't know what is the wrong?pls help ,thanks!

Answer 1

[Asim]

Hello,

I've successfully regenerated the example on my end. Could you please double-check the steps you've followed? If you encounter any errors during the process, kindly attach a screenshot or copy of the error message, along with the configuration parameters you've used. This information will greatly assist in troubleshooting the issue.

Thank you.

Answer 2

[Abhishek GS]

Ensure that you have selected the right xtal clock frequency based on your board. STD boards typically have 20MHz and COM boards have 25MHz