how to use MATLAB to configure the USRP 2943R with a PCIe cabl
28 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
Hi,
I connected USRP 2943R to PC using a PCIe cable. Can I use MATLAB to configure the USRP 2943R with a PCIe cable?
Best regards,
Zohreh
0 commentaires
Réponses (2)
Francisco Salomon
le 24 Jan 2024
Hi Zohreh,
PCIe is not supported at the moment on MATLAB Support Package for USRP (Communications System Toolbox) or Support Package for NI USRP Radios (Wireless Testbench).
You will need to use a network interface. Please refer to the relevant product's documentation for your MATLAB version.
Thanks,
Francisco
0 commentaires
Basmah Ahmad
le 8 Jan 2024
Yes, you can use MATLAB to configure and control a USRP 2943R connected to your PC via a PCIe cable. MATLAB provides support for USRP devices through the Communications System Toolbox and the corresponding support package for USRP. Here is the general step to get started:
Install MATLAB Support Package for USRP:Make sure you have the Communications System Toolbox installed, and then install the MATLAB Support Package for USRP. You can do this using the MATLAB Add-Ons Explorer or by using the following command in the MATLAB command window:
matlab.addons.installedAddons('usrp')
4 commentaires
Mir
le 23 Jan 2024
I am getting the same error. The reason for this is the IP Address which is a default property of the comm.SDRuTransmitter system object with default IP address of 192.168.10.2. You may try with higher version of MATLAB i.e 2022b where you have a support for Wireless Testbench and Support Package for NI USRP Radios. You can configure your NI USRP with these support packages. Currently, I am limited by the Windows 7 on my NI PXIe controller.
HTH,
Mir Lodro
Voir également
Catégories
En savoir plus sur Communications Toolbox dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!