How to auto-adjust the subsystem height to make the spacing between adjacent ports consistent？

When I increase or decrease the number of ports of a subsystem, the spacing between two adjacent ports will be change if I don't adjust the height of Subsystem.

I hope that the subsystem ports spacing can be consistent throughout my entire model，So I use something be like the code below to adjust the height of selected subsystem:

portsNum = max(inputPorts_Num, outputPorts_Num);

Sub_Pos = get_param(gcbh,'Position'); %select target subsystem

NewHeight = old_pos(4)-old_pos(2)+temp*portsNum; %Calculate the new height of subsystem according to the number of ports

Sub_Pos = [Sub_Pos(1) Sub_Pos(2) Sub_Pos(3) Sub_Pos(2)+NewHeight];

set_param(gcbh,'Position',Sub_Pos);

But, I found that how much height of subsystem should I change to keep the spacing between adjacent ports consistent, is not as simple as I thought.

I try to increase more ports，adjust the height manually to make the spacing consistent，and then get the Position value to cal the increased height，try to find out the rule between ports-increasing and height-adjusting.

and there seems to be no rules...

I know a stupid way to achieve my purpose: Increase more and more ports and cal every height vale to make an Height-array. Then look up table.

But that's really stupid...

Can anybody help me to do this by a smarter way? Thank you very much.

Answer 1

[Fangjun Jiang]

I had this problem before. I didn't find an exact formula. I suggest not looking at the previous height. Just use this formula to set the height. Height=Spacing*(portsNum+1). For a range of Spacing and portsNum, it works pretty well.

[一阳]

Awesome!

It do works pretty well!

Thank you very much My friend!