- Unit Delay: Ensure the unit delay is placed correctly to break algebraic loops without unintended delays.
- PI Parameters: Start with a low P gain and adjust the I gain for settling time. High P gain can cause drift.
- Review Configuration: Verify RTU box settings match your PLL application (reference frequency, scaling).
- Hardware Check: Look for loose connections, component tolerances, or noise issues.
PLL phase-locked frequency failure
6 vues (au cours des 30 derniers jours)
Afficher commentaires plus anciens
I used the RTU box 204 to build the PLL phase-locked loop, in order to eliminate the algebraic loop, in the phase wt and dq transformation between the feedback loop added unit delay module, the interrupt frequency is 10kHz, but the frequency of the phase-locked slowly increased from 50Hz to more than 70Hz; If the unit delay module is removed it indicates that there is an algebraic loop code generation failure. The PI parameters of the phase-locked loop have been changed, but the frequency keeps increasing. Where should I troubleshoot the problem?
0 commentaires
Réponses (1)
UDAYA PEDDIRAJU
le 6 Juin 2024
Hi Xin,
Your PLL drift using RTU box 204 likely stems from the unit delay or PI parameters.
Consider monitoring the phase error signal for troubleshooting.
0 commentaires
Voir également
Catégories
En savoir plus sur Phase-Locked Loops dans Help Center et File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!