Hi Nishant,
I believe you are referring to the following model present on the MathWorks documentation page - https://www.mathworks.com/help/sps/ug/solar-pv-system-maximum-power-point-tracking-using-boost-converter.html
The above-mentioned model has not been tested using “speedgoat” hardware as there is no block present to configure it and it is not being done programmatically.
Further upon inspecting the model settings, it can be seen in the hardware implementation that the “Hardware board” is set to “Determine by Code Generation system target file”. The system target file defines the run-time environment. The code generation system target file for this model is “grt.tlc” which is the “Generic Real Time” target and is not intended for “speedgoat” hardware. You can learn more about the differences between “Generic Real Time” target and “Simulink Real Time” target (speedgoat.tlc) from here - https://www.mathworks.com/help/rtw/ug/compare-system-target-file-support.html#bvly876-1[SG5]
Hope this answers your question!
