Issue with 8 Qam demodulation & other modulation orders in simulink HW SW codesign model

Hello,

I am doing a project which involves use of adaptive modulation schemes (BPSk, QPSK, QAM) using target Tx & Rx as USRp e310 sdr. I am using sw hw co design in matlab to do the same. I have taken reference already available example Qpsk targeting usrp sdr for implementing 8 Qam demodulation but encountered with an error saying

Baseband': Fixed-point input data types are only supported when the 'Decision type' parameter is set to 'Hard decision' and the 'M-ary number' parameter is an even power of two.

Component:Simulink | Category:Model error

An error occurred while propagating data type 'sfix32_En30' from 'usrpe3xxHWSWQAMSL/HDL_QAM/QAM Tx Channel QAM Rx/QAM Rx/QAM Demodulator/Delay', 'Output Port 1'.

I tried with converting to integer & forwaded to 8 qam demodulator but remains unresolved.

8 qam demodulation is important in my case considering limitation of snr over long distances, other even power of 2 qam mod scheme such as 4, 16 demodulator works without an issue , but in case of 16 qam, it is difficult to deal with processing as fixed point goes to 64(16symbols * 4samples/sec) & matlab discreate fir filter doesn't support that saying above 128 is not supported . also if I drop the sample rate per symbol to 2 there is issue with fifo in the design.

i am matlab 2024a relesse for the design.

Please help me rectifying the issue, it will be helpful in addressing the issue faster.

Thank you in advance!